Learning Forum

[Md_Salem]

Hello everyone,

I am using Design modeler to construct an optimization problem

I defined two dependent parameters (H8,V6) in the Design modeler as shown in the next two pictures as well as independent parameters

my question here is, how do I set some unequility constraints on the dependent parameter given that they don't appear as parameters in the optimization section since they are dependent on other parameters?

[Gary Stofan]

Hello

Here is one idea: 

In DM, you can create "dummy parameters"  then define geometry based on that dummy parameter. 

Then in a DOE optimization, you can assign a range to that dummy parameter.

 

 

Another idea may be this: 

This will work only for a  Direct Optimization type, not say a Response Surface.

 It is possible to define a bound that is say an equation based on other values. 

 

 

 It is done in the Parameter Relationships section. 

[Md_Salem]

Hello,

The attached picture couldn't be loaded properly.

Would you reload it again ?

Regards