We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Ansys AQWA: Meshing and connection errors › Reply To: Ansys AQWA: Meshing and connection errors

September 23, 2024 at 6:21 pm
S.S.S.ShankaVasuki
Subscriber

Hi can someone help me out with this?

Now, I remeshed the geometry with triangular elements to get a total number of panels as 20363 and out of this 0.04% of the elements seem to fail hence, I also enabled the ignore modelling rules and the diffraction analysis runs without any errors. But I get a lot of errors in the hydrodynamic response analysis

I have currently reduced the number of connected bodies to three bodies to simplify the problem. But I still get a lot of errors as shown in the figure below.

I am not quite sure on why these errors pop up. Is it because aqwa cannot simulate floating structures with a small draft? or am I missing something here?

Do I have scale up the model?

So can you please help me with resolving these errors?

Thanks!