-
-
September 20, 2024 at 4:07 pmAn_Engineering_StudentSubscriber
Hi, I am using ansys 2024 R2 student software. During one of my analysis i got an error "An internal solution magnitude limit was exceeded. Please check your Environment for inappropriate load values or insufficient supports. Please see the Troubleshooting section of the Help System for more information." I got this duing solving. i am attching below screenshots to give you and idea of what i was doing.
What i am trying to do is static structural analysis on a design of weldments. I had created the design in solidworks, inported in to ansys as a parasolid file, and extracted the line bodies from it using spaceclaim. I then generated a defaut mesh, and provided fixed supports as below:
i hadgiven the fixed supports the vertices marked in green. i then proceeded to add a 2KN force on the top point of the triangle in the y direction
and every time i try to solve this i get the error :
it will be highly helpful if anyone can help me solve this.
-
September 20, 2024 at 4:42 pmErik KostsonAnsys Employee
Hi
Common issue when using beams or multiple parts. At the moment the beams/members are not connected to each other at common vertex.
USe shared topology in spaceclaim to connect all the beam nodes shared by the members (now they are not connected as we said).
The below video at a time ~ 3 minutes and 40 sec. into the videoclip shows how to share topology and connect them at common vertices.
https://www.youtube.com/watch?v=hb7BUcug8wY&t=435s
All the best
Erik
-
September 21, 2024 at 3:28 pmAn_Engineering_StudentSubscriber
Thanks a lot!!
-
September 23, 2024 at 8:20 amErik KostsonAnsys Employee
More than welcome - closing this as others might find it helpful.
Erik
-
-
-
- You must be logged in to reply to this topic.
- Problem with access to session files
- Ayuda con Error: “Unable to access the source: EngineeringData”
- At least one body has been found to have only 1 element in at least 2 directions
- Error when opening saved Workbench project
- Geometric stiffness matrix for solid elements
- How to apply Compression-only Support?
- How to select the interface delamination surface of a laminate?
- Timestep range set for animation export
- Image to file in Mechanical is bugged and does not show text
- SMART crack under fatigue conditions, different crack sizes can’t growth
-
1281
-
543
-
524
-
225
-
209
© 2024 Copyright ANSYS, Inc. All rights reserved.