We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › LINK 180 only tensile behaviour › Reply To: LINK 180 only tensile behaviour

September 17, 2024 at 8:57 am
Erik Kostson
Ansys Employee

 

 

 

Hi

First use SECCONTROL,,1


Then

See the doc./help manual on LINK180.

(Nonlinear iterative solution is needed for tension or comp. only – so use in /SOLU , NLGEOM,ON, and NSUBST etc.).

https://innovationspace.ansys.com/forum/forums/topic/problem-with-the-link180-element/

 

All the best

Erik