We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Warning: “Outlines on High Priority Represent Faces Are Not Preserved Well” › Reply To: Warning: “Outlines on High Priority Represent Faces Are Not Preserved Well”

September 15, 2024 at 2:08 am
spate035
Subscriber

Hi Jason,

I was able to resolve the issue after re-examining the geometry. It turns out my 2nd waveport was completely covered by a PEC on one side (which is necessary), but also partially covered by a PEC on the other side. Once I changed this the warning went away.

Thank you,

Shyam