We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Materials › S-N (Wohler Graph) for steel X153CrMoV12 / D2 / NC11LV / K110 or similar › Reply To: S-N (Wohler Graph) for steel X153CrMoV12 / D2 / NC11LV / K110 or similar

September 4, 2024 at 7:02 am
Michał Marszałek
Subscriber

 

Unfortunately, this software is not available for students… And here I have a request, could you send me a picture of the table for the (S-N) graph, stress on the Y axis and the number of cycles on the X axis? I am conducting a fatigue strength analysis of the jaw for my engineering thesis and everything comes out correctly (maximum stress, deformation), but in the fatigue tool the number of cycles for life always comes out maximum and this must be due to a bad S-N graph (found in some publication) and unfortunately I can’t find another one and I’ve searched the entire internet.

Â