We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › message when unfolding with 2024r2 › Reply To: message when unfolding with 2024r2

July 29, 2024 at 8:22 am
Roberto
Subscriber

Hello, I think this writing is there because in some cases if you place the development on the table the positive and negative dimensions of the folds are wrong and you get the wrong piece