Learning Forum

[orihuelaalbaantonio]

Hello , i hope you're all doing well at this time.

Currently im doing an Ansys Simulation over a NACA 2412 , i´m trying to make an structured mesh by aplying the criteria of number of divisions over my "C shape" fluid domain and the bias factor, but i havent had any success. Since i dont have a lot of experience in structured mesh im following this youtube tutorial but when im performing my meshing i keep getting these messages in my command bar .
For better understanding i´m uploading this screenshot and the youtube link , hoping anyone could give some useful advice.

https://www.youtube.com/watch?v=3i9Ryq-m1HA&t=1250s

Further more i salute you all.

[Rob]

Have a look at what Hard and Soft means on the edge sizing.