We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Installation and Licensing › Ansys Products › Poor quality mesh at trailing edge for 3d wing › Reply To: Poor quality mesh at trailing edge for 3d wing

July 12, 2024 at 2:10 pm
Rob
Forum Moderator

Have a look at what sizing you're using. If you're using a mix of hard edge/surface control and size function then odd things can happen. 

If the jet is likely to oscillate you may find the residuals don't drop for a steady run. That's why we use monitor points.Â