Ansys Assistant will be unavailable on the Learning Forum starting January 30. An upgraded version is coming soon. We apologize for any inconvenience and appreciate your patience. Stay tuned for updates.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Collison with frictional contacts › Reply To: Collison with frictional contacts

June 5, 2024 at 11:08 pm
mrom0007
Subscriber

 

I swapped to a displacement load, and I am getting some errors now I am unsure about

*** ERROR ***                           CP =      86.234   TIME= 09:03:44
 Solution not converged at time 0.5 (load step 1 substep 1).            
  Run terminated.                                                       

 *** WARNING ***                         CP =      86.234   TIME= 09:03:44
 The unconverged solution (identified as time 1 substep 999999) is      
 output for analysis debug purposes.  Results should not be used for    
 any other purpose.                  

 

 

I am also getting this one:
 
 
The solver engine was unable to converge on a solution for the nonlinear problem as constrained.  Please see the Troubleshooting section of the Help System for more information.
 
I am a bit unsure about these errors 

 

[bingo_chatbox]