Ansys Assistant will be unavailable on the Learning Forum starting January 30. An upgraded version is coming soon. We apologize for any inconvenience and appreciate your patience. Stay tuned for updates.

Ansys Learning Forum Forums Discuss Simulation General Mechanical Transient Structural Failure Analysis for a Low Tension Dead End Clamp Reply To: Transient Structural Failure Analysis for a Low Tension Dead End Clamp

Ahmed Baig
Subscriber

My static friction coefficient is 0.36. I calculated that myself using the pieces I have available at hand.

Regarding the displacement, how do I apply displacement gradually? I know that the UTM functioned under the setting of guarenteeing 5mm/min of displacement by varying the load magnitude as the piece deformed.

The UTM was able to achieve failure after 8 minutes.

[bingo_chatbox]