We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Calculation Slot Fill Factor › Reply To: Calculation Slot Fill Factor

May 9, 2024 at 2:30 am
Reshmi Raghavan
Ansys Employee

Hello Andreas,

The slot fill factor is calcualted as . RMxprt assumes that the coils are placed one above the other and one beside the same as shown i the below figure.

 

So the total area of the coil can be considered as = 17*11*0.965*0.965/299.188 =58.2038percent