We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › (Rolling) Sheet thickness after rolling doesn’t match the roller’s gap › Reply To: (Rolling) Sheet thickness after rolling doesn’t match the roller’s gap

April 26, 2024 at 2:34 pm
sgkcompany
Subscriber

Thank you for helping.
What do you mean ''try defining two contacts on the wheel and plate with the same contact/target side selectons'', you mean I can have a plane have both contact and target side?
Roll to roll use ''gauss point'' or ''normal from contact''? But normal lagrange can't use gauss point. Can you give me more info about it.