Reply To: Bonded contact in a non-linear material analysis

[cristian.pujol]

Thanks for you're answer 

The problem with shared topology is that i can't use it because i have two materials, the big tube is S355 and the other tubes S690

For S355 I used Yield stress 350 MPa and tangent modolus of 2100MPa

For S690 I used Yield stress 690 MPa and tangent modolus of 4140MPa.

So in this case where we have two materials what would be the procedure for "gluing" the two tubes?

 

Thanks in advance for the answer

Regards