We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Probem with modal Analysis › Reply To: Probem with modal Analysis

April 1, 2024 at 2:38 pm
Erik Kostson
Ansys Employee

Make sure all your elements are connected - for a large ship frequencies of global modes (say 1st bending mode) should be below the local panel modes.

Acoustic elements are way to complicated and comp. intensive for a global analysis of ships (vibration).

There used to be a Guyan reduction to do as you mentioned, but since the mass (matrix - depends of choice of masters which is tricky) is approximate I do not think it is supported anymore.

All the best

Erik

Â