-
-
March 26, 2024 at 1:08 pm
Jason Moss
SubscriberHello,
I received the following error message when attempting to solve the turbulent component during a flow analysis in Fluent.
The laminar component solved without issue. Is this error message a result of Fluent setup or is it the result of computer related issue ( ex: corrupted workbench file, etc.)
Thanks in advance,
-
April 2, 2024 at 5:42 pm
Federico
Ansys EmployeeHello Jason,
it is difficult to say from this information alone. The error just says that the solution for the system called “Turbulent” failed.
Can you provide more details on the changes that you made from your Laminar setup to the Turbulent setup which may have caused this?
-
April 2, 2024 at 6:24 pm
Jason Moss
Subscriberthanks for the response. turns out that the component was indeed corrupted and was successful after creating a new workbench file.
-
April 3, 2024 at 11:43 am
Federico
Ansys EmployeeGood to know that you resolved the issue!
-
-
- The topic ‘error message for Turbulent solution component in Fluent’ is closed to new replies.
- air flow in and out of computer case
- Varying Bond model parameters to mimic soil particle cohesion/stiction
- Eroded Mass due to Erosion of Soil Particles by Fluids
- Centrifugal Fan Analysis for Determination of Characteristic Curve
- Guidance needed for Conjugate Heat Transfer Analysis for a 3s3p Li-ion Battery
- I am doing a corona simulation. But particles are not spreading.
- Issue to compile a UDF in ANSYS Fluent
- JACOBI Convergence Issue in ANSYS AQWA
- affinity not set
- Resuming SAG Mill Simulation with New Particle Batch in Rocky
-
3862
-
1414
-
1220
-
1118
-
1015
© 2025 Copyright ANSYS, Inc. All rights reserved.