We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Errors with Topology Analysis › Reply To: Errors with Topology Analysis

March 18, 2024 at 9:24 pm
Daniel Barvenik
Subscriber

Hi Ashish,

Unfortunately no.  Following that link, Nanda Veralla suggests to:

  1. Go to the Start Menu and open %temp% folder. Search for ‘.ansys’ folder and rename it to ‘.ansys.old’ then launch the application. 
  2. Open a file explorer and type %appdata% in the address bar.

     Locate the Ansys folder --> select version (V231) and rename it to V231.old

I did #1 but when tried #2 I could not find an ansys folder in appdata.

So I tried rerunning it after renaming .ansys to .ansys.old, but same error.

I am using 2019 R3 by the way.

I then followed Gary Stofan's link that is linked on that site.  I tried retaining design points.  I went to "Tools > Options > Appearance…scroll down to “Beta Options” and check the box".  Then made some parameters like maximum stress and followed the instructions to retain design points.  But that didn't help.  Same error.

I also did not find a file with the name ansyswbdumpfile.dmp.

 

Still looking for help getting this basic run to work!