We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › V-bending problem using Transient Structural › Reply To: V-bending problem using Transient Structural

March 13, 2024 at 9:28 am
peteroznewman
Subscriber

Cut the geometry in half along the Y axis and delete the three pieces on the -X side. Apply a Displacement boundary condition of X = 0 to those edges. This will help control the sheet metal part.

Under analysis Settings, use a large number of substeps, say 100,  for Initial, Minimum Substeps and a very large number of substeps for Maximum like 1000.