Crack growth error

- March 12, 2024 at 1:23 am
  
  Tasuku Ito
  Subscriber
  
  A semi-elliptical crack is inserted into the inner wall of a circular pipe, and a load is applied in the opposite direction to the direction of crack growth. And the result of this is always not parsed to the end and stops midway. In addition, the crack growth suddenly becomes linear from the middle. Please let me know the cause of such an error.
- March 19, 2024 at 2:31 am
  
  Ashish Khemka
  Forum Moderator
  
  Hi,
  It would be difficult to comment without looking into the model and Ansys employees cannot help you with the same on forum. Please wait for other members o repond. In case you have access to Ansys Technical support then you can raise a case over there.
  
  Regards,
  Ashish Khemka