We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › How to add a ferrite material to Maxwell › Reply To: How to add a ferrite material to Maxwell

February 1, 2024 at 3:59 pm
Ivonne Marti
Ansys Employee

Hi Nick,

In your material properties you are introducing two curves, one at 50kHz and another at 200kHz. The frequency range between them is very large. Usually, you should add several curves with a little frequency difference, for example 200kHz, 250kHz, 300kHz or even closer.

If you only want to use the core loss curve at 200kHz, then I would advise you to remove the 50kHz curve. In this case the blue curve will be very close to the core loss curve you introduced.

Regards. Ivonne