We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
sanchit2208
Subscriber

I have not checked with IT as I was'nt having this problem uptil now. For the same geometry, mesh but with different boundary condition I've never run into this issue. 

I'm using a transient pressure profile as a boundary condition. For relatively lower back pressures, I didn't run into this issue. But lately, with a higher back pressure this issue persists. The simulation runs for roughly 26hrs and then crash.