Cannot move on to ansys fluid flow icing

- January 25, 2024 at 1:49 pm
  
  Eunkyung Cho
  Subscriber
  
  Hello, I am trying to simulate ice over a 2D airfoil. Therefore, I created a C-type mesh and trying to run the simulation. Now, I am trying to connect the file to fluid flow-icing. However, it gives me following error:
  Does anyone know how to solve this issue?
- February 1, 2024 at 4:43 pm
  
  Rahul Kumar
  Ansys Employee
  
  Hello,
  Please ensure that your mesh does not contain polyhedral or adapted elements. The reference conditions and material type (Air) should be suitable for icing conditions. Here is a reference to a simulation: ANSYS Fluent Icing: Conducting a Fluent Airflow Simulation on Clean NACA0012 Airfoil - Ansys Knowledge
  
  I hope this helps.