Angular deformation

- April 6, 2019 at 4:29 pm
  
  kiranhr
  Subscriber
  
  I have modelled a composite shaft with 15 layers of glass fiber and applied a torque of 400Nm on one end with fixity at the other end. I have done the same modelling in APDL and I have obtained an angular deformation of about 0.1202rad. But in workbench(ACP) I am not getting the result correctly? Also I would like to know how to extract angular deformation in workbench?
- April 7, 2019 at 1:40 am
  
  peteroznewman
  Subscriber
  
  Use a Flexible Rotation Probe on the edge.
- April 26, 2019 at 5:30 am
  
  kiranhr
  Subscriber
  
  I am not getting how to use the flexible rotation probe. If you have any resources or examples regarding the same would help a lot.
- April 26, 2019 at 5:40 am
  
  kiranhr
  Subscriber
  
  What I came to know through internet is along with flexible rotation probe, few APDL commands should also be used to extract angular rotation. Is it the case, that should we use flexible rotation command?
  
  Any resources or video regarding the same will be of greatest help.
  
  Regards,
  
  Kiranhr