3D Design

3D Design

Topics related to Ansys Discovery and Ansys SpaceClaim.
  1. All Channels
  2. 3D Design
  3. winglet geometry

winglet geometry

    • March 25, 2019 at 7:22 am
      veera
      Subscriber

      hi gd aft non to all


      now i am designing blended winglet in ansys workbench , when i am doing winglet from wing tip (47.73 sweep angel) , its always coming like that showed in figure , but my requirements is that marked region should not cross the wing end  


      anybody help me 

    • March 25, 2019 at 11:38 am
      Rob
      Forum Moderator

      Please can you post an image of geometry before the blend too? 

Viewing 1 reply thread
  • The topic ‘winglet geometry’ is closed to new replies.
Innovation Space
Top Contributors

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.