General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. MSUP VS FULL transient analysis

MSUP VS FULL transient analysis

    • January 26, 2019 at 6:45 pm
      SuvashChapain
      Subscriber

      How do we select full transient analysis in workbench interface?. Mode Super does not take the damping, I need to switch from MSUP to full transient analysis.

    • January 26, 2019 at 8:36 pm
      peteroznewman
      Subscriber

      In Workbench, delete the link between the Solution cell on the Modal analysis block and the Setup cell on the Transient Structural block, then it will not be a MSUP analysis.

Viewing 1 reply thread
  • The topic ‘MSUP VS FULL transient analysis’ is closed to new replies.
Ansys Innovation Space
Top Contributors

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.