Ansys Learning Forum › Forums › Discuss Simulation › Electronics › ACIS Error after adding solder mask thickness in the HFSS design!!! › Reply To: ACIS Error after adding solder mask thickness in the HFSS design!!!

December 5, 2023 at 10:21 am
Praneeth
Ansys Employee

Hi Imtiaz,

Thank you for reaching out to the Ansys Learning Forum. Your patience on this is much appreciated.

Please provide more details to help us serve you better - which version and design type is used, which guidelines you are referring to.

It is hard to comment on the correctness of the results. Did you observe any difference in results between the models with and without the solder mass thickness?

Best regards,
Praneeth.