Learning Forum

[Ruairí Brady]

Hi, I have a valid Ansys licence. When I try to use Fluid Flow (Fluent), importing my geometry works fine. Updating it and slicing my mesh works fine. Then, trying to update it under Setup causes the progress bar to freeze at 66%.

Has anyone experienced this or could provide some support?

Thanks

 

[George Karnos]

If the user is right clicking on setup cell and selecting update, then the user can instead try to open Fluent and see what happens. 

Also what happens if a new Fluent component system as added without any date (setup and solution cell only). does Fluent launch from inside workbench ?