Restricting deformation upto certain length in particular direction

- November 20, 2023 at 10:21 am
  
  suryakant.koshta
  Subscriber
  
  In the given figure because of the buckling due to applied load in -Y direction, highlighted green edge will deform in X direction but i want to deform it upto 30mm in x direction so if i will give displacement boundary condition on this edge, it will capture the actual deformation of this body in case of buckling?
- November 22, 2023 at 2:59 pm
  
  Ashish Khemka
  Forum Moderator
  
  Hi, you can create a rigid surface at a distance of 30mm in the x-direction and define a contact between the edge and surface.
  Regards,
  Ashish Khemka
  - December 14, 2023 at 7:01 am
    
    suryakant.koshta
    Subscriber
    
    thanks Ashish