Workbench how to set boundary conditions

- November 14, 2018 at 1:53 pm
  
  h395523899
  Subscriber
  
  I use the fluent in the workbench, build the model with spaceclaim, meshing the mesh, but the boundary conditions of the model imported into the fluent are messy.
  
  In which pre-processing software should I set each boundary condition?
- November 14, 2018 at 2:01 pm
  
  Rob
  Forum Moderator
  
  If you mean how to label them, use Named Selections in Meshing. These (by default) will pass into Fluent and can be set.
- November 15, 2018 at 4:53 am
  
  Keyur Kanade
  Ansys Employee
  
  You can set the Named Selection in SpaceClaim (as groups) or in Meshing.
  
  It is always preferred to give Named Selection in Meshing.
  
  You can only give names in meshing. These named selection will appear in Fluent as boundary zones and cell zones. You need to set boundary conditions in Fluent.