The current Max Size will create too many initial cells in assembly meshing

- November 1, 2018 at 3:07 am
  
  ksh8199
  Subscriber
  
  Hello!
  
  I was following the tutorial uploaded in the YouTube.
  
  https://www.youtube.com/watch?v=9tKLL7P5_t4
  
  I downloaded the youtuber's geometry so there will be no problem with the geometry
  
  and i follow up the setting for mesh as he did.
  
  but i faced the warning massage below
  
  "The current Max Size will create too many initial cells in assembly meshing. As a workaround, please increase
  
  the Max Size by a factor of 100 and then scope a soft Size mesh control to all bodies using the current Max Size value."
  
  Is it because of the hardware problem?
  
  Should i run the program in the more powerful computer?
  
  Thanks!
- November 1, 2018 at 3:17 am
  
  Keyur Kanade
  Ansys Employee
  
  Hi,
  
  Please check the extends of your geometry. i.e. min and max x,y and z.
  
  From image of this youtube, it looks like the geometry has around 1m dimension in Y.
  
  Also with student version the max limit of cells you can solve is 512K.
  
  Regards,
  
  Keyur