We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Via hole creating › Reply To: Via hole creating

September 22, 2023 at 2:50 pm
GioF
Ansys Employee

I don't understand your question. 

Create Cylinder -> assign Polymer -> Subtract Cylinder from Substrate (enable Clone tool objects before operation) -> add Finite Conductivity for Face part of Cylinder 

If you follow the order above you should be fine.