meshing problem

- August 28, 2023 at 11:35 am
  
  carlson ngeno
  Subscriber
  
  hello everyone. i am currently doing a project in which i want to simulate how changing the profile of the aircraft engine nacelle chine/strake affects aerodynamic drag during cruise. i would like to generate a high quality mesh in ansys workbench but i am stuck . i would like to use zone division grid generation technique to generate a high quality mesh that will enable me to simulate the effect of adding an engine nacelle strake/chine to the drag and also the lift to drag ratio.
  the image below shows the mesh i have been able to generate.Any kind of help or pointers on how to achieve that would be greatly appreciated.
- August 28, 2023 at 11:52 am
  
  carlson ngeno
  Subscriber
  
  https://community.ansys.com/?status/52872-52872-1692871300
  this is a link to more on the same