Reply To: Specific nodes number in fluent mesh?

[Sampat Kumar]

 

Hi schultz wei,
It is very difficult to keep the same mesh number every time with changes in the geometry. Mesh numbers slightly vary even if you change the Ansys version or open the same geometry in a different workbench and mesh it with the same setting as you have done in the same geometry in other workbench files.  
Although I suggest some points that might be helpful to keep the same mesh number in a simple geometry,
1. control the mesh by specifying the number of divisions on the edges or faces while meshing and set it to a hard setting. This can help you have a more consistent number of nodes for different models with minor geometric variations.

This is the FEA Structural forum group, and your problem is related to fluent meshing, you can ask this question to the fluent group by using the mentioned link. Our fluent team will help you there too.

/forum/forums/forum/discuss-simulation/fluids/

Regards,
Sampat