We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Coordinate system Sketch mode › Re: Coordinate system Sketch mode

November 7, 2022 at 4:50 am
Devendra Badgujar
Forum Moderator

Hi Christof Schramm

Try clearing your user settings from File > SpaceClaim Options > Advanced > Reset All User Settings.

Please check if your Top view direction is set to Y axis. You can check this from File>SpaceClaim options>Advanced>Behavior.

If not, please set it to Y axis then open new design and try. 

If the problem persists, please share a short video with exact steps to reproduce this issue. 

Regards.Â