Learning Forum

[sameep11]

I am going through the edx hand on course but stuck there in 1.5 homework i gone through all the lecture but dont able to get the output below is my work plz someone help me in removing it

[Sandeep Medikonda]

Hi sameep, 

Please provide more details on what is wrong and what your expectations are from the results?

~Sandeep

[sameep11]

75

it is expected

mine max temp is 6.75 but the output is 7.5 

i used heat flux=-0.5

better go for the A hand on course on engineering simulation from edx 1.5 home work numerical result module

thanks for the support

[peteroznewman]

Hello Sameep,

Please show that you applied the proper BCs.

Also, please show that you have the correct material properties

[sameep11]

what is Bcs?

[sameep11]

got it i have put the same bcs

[sameep11]

but ig not 2d conduction
thanks for the reply

[peteroznewman]

If you are referring to where my image says: A: 1D with Internal Heat Generation, that is because I renamed the system block from Steady State Thermal on the Project page of Workbench.  That can be useful when you have several blocks on the page since the label shows up in the plots!

I don't see any images in your reply. You have to save to a file before you can add them to your post. You can grab and paste from the clipboard.  Is your model giving the correct temperature now?

[mohamed elbanhawy]

 

 In the picture This errors happened when i try to solve in ansys Fluent and when i tried to open results in the workbench it gives me this message "no applicable licences available right now " >>> what should i do to solve that  

 

 

[sameep11]

i didnt get the add material option

[sameep11]

 

 

is anybody give the correct answer of the energy balance?

[peteroznewman]

sameep11,

In your post above, no one here is going to give you the correct answer to a question from the edX course.

In your post two above, I see you have a material called sameep that has the thermal conductivity property, but the drop down menu is covering up the value assigned and the units.

I ask again, is your model now giving the correct temperature result?

 

[sameep11]

no my temp is wrong

[peteroznewman]

You didn't show a screen snapshot of your model with the boundary conditions, the way I showed in my screen snapshot.

[sameep11]

May i have your mail id?

[sameep11]

I have got the same result as yours but dont get the right temp value yet

[DrAmine]

Please be more precise about your questions? Are you now asking about Fluent or still regarding ANSYS with the edx workshop? If yes show the screenshot of your model with all boundary conditions as highlighted by peteroznewman