Getting a different inlet velocity value

- August 4, 2023 at 12:34 pm
  
  Kauê Castro
  Subscriber
  
  Hello, Im having a rather simple problem: The velocity I get when simulating is different of what I specificated in the boundary conditions panel, Im using a velocity profile that I had previously simulated, that has a max speed of 10.5 m/s approximately.. when simulating, the jet only envolves 1.05 m/s max velocity. Im using only one cell condition that depicts the fluid domain.
- August 4, 2023 at 12:41 pm
  
  Rob
  Forum Moderator
  
  Do the coordinates of the profile file match the boundary it's attached to in the new model?
- August 4, 2023 at 12:45 pm
  
  Kauê Castro
  Subscriber
  
  I've made sure it matches yes, including the mesh.
- August 4, 2023 at 12:56 pm
  
  Rob
  Forum Moderator
  
  It should be OK then. Can you post velocity contour plots of the two surfaces with node values off?