Learning Forum

[luh1]

Hi,

I am a starter of Lumerical and I am having problem about 3D FDTD simulation. The port (called input ) in my simulation takes too much memory as shown in the graph.

I lowered my frequency points to lower than 5, and I put my ports close to each other as possible, but the memory is still big. I need the port to get S-parameters. Is there any way to minimize the memory used by the port?

[Lito]

@Haoxiang Lu, 

Please post your request in the Photonics - Ansys Forum section. A Lumerical Application Engineer will assist your concerns in the Photonics - Ansys Forum. Thank you!