We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Limiting deformation upto a value › Reply To: Limiting deformation upto a value

July 12, 2023 at 2:10 pm
peteroznewman
Subscriber

Hi Hakim,

Have you already pulled on the front face of the block and observed > 5 mm directional deformation of the sides of the box?  If you got less than 5 mm then you can skip modeling anything inside the box!