Learning Forum

[Mohan.Karantha]

Hi 

I am working on Fluent, where i want to define Mesh Interfaces .But for my model Mesh interface option is disabled.

I can see the Contacts in Meshing module. why i can't see that in Flunet window.

 

 

Please refer above images. Where i m doing wrong?

 

Regards,

Mohan

 

[vganore]

Can you share the workbench project file to understand it better?

[Mohan.Karantha]

Hi Vishal,

 

I can't upload .wbpj file here.Can you share your mail id so that i can share it.

 

Thank you reagards,

 

Mohan

[peteroznewman]

Please follow these directions to upload a .wbpz file which is allowed.

[Mohan.Karantha]

Please find the attached file.

[raul.raghav]

Mohan, there are no attachments in any of your posts.

[Mohan.Karantha]

I tried to upload the files. But it fails.. File has 155 MB. still it fails to upload.

[raul.raghav]

Unfortunately, the file size is restricted to 120Mb. Could you upload it to google drive and share it?

[Mohan.Karantha]

Hi,

 

Please find the below link for the file.

 

https://drive.google.com/open?id=1pGg0T-In7aDsu3IwwzL-Cj5VTBOEH-s5 

Regards,

Mohan

[raul.raghav]

I copied your Fluent workspace and worked my way in the copied workspace. I opened the geometry to make sure everything was right there and it was. I opened the mesh and deleted the connections and created new connections automatically. I used "multizone" meshing method for the coil and the water inside it while I used a patch conforming mesh for the outer air domain. I then built the mesh focusing on the number of mesh elements (assuming that you have Ansys Student License). Then I opened Fluent setup and I could see the mesh interfaces tab active. Attached is the modified workbench archive file if you want to take a look into it.

The modified workbench archive file: Heat Exchanger

 

[Mohan.Karantha]

Thank you very much Rahul. May i know which version of Ansys you are using?

 

Regards,

Mohan

[raul.raghav]

Mohan, I used Ansys Student v19.0 when I worked with your files.