Learning Forum

[Andres Felipe Valencia]

Hello everyone, cardiologist here just starting with 3D modeling. I am using Ansys discovery and I am trying to manipulate the sketch plane to be on a very precise position in the Aortic valve entry, so far with no success. I was wondering if there is any way to give to the sketch plane an exact numeric tilt angle input  and position on the given geometry. Thanks

[Ashish Khemka]

Hi,

Create the sketch plane and then follow the steps as indicated:

Regards,

Ashish Khemka

[Andres Felipe Valencia]

Thank you Ashish, your response was very helpfull. Do you know where could I find further documentation for this kind of "basic" use and manipulation of the sketch axis.