Remote Displacement, weird expansion result

- December 24, 2017 at 5:42 pm
  
  jonnyflowers
  Subscriber
  
  So I have a simulation that involves a 90 degree twist on a block, I have used remote displacement to apply this to my model, however I seem to get a very strange expansion. It seems to expand one end of my model and only twists it by about 45 degrees. What could be causing this?
  
  I have other models running these same displacements.
  
  The settings applied to my remote displacement are below
- December 27, 2017 at 1:15 am
  
  peteroznewman
  Subscriber
  
  Check if Large Deflection is Off under Solver Controls in Analysis Settings. That would explain it. Large Deflection needs to be On when rotations are large.
- December 28, 2017 at 1:49 pm
  
  jonnyflowers
  Subscriber
  
  Thanks, that was it, I had it turned on for the wrong step