external pressure field as APDL-command in Workbench

- November 28, 2017 at 11:55 am
  
  hosis86
  Subscriber
  
  Hi everybody,
  
  I'm building a model in Ansys where I should put a pressure field calculated in MATLAB on my structure. I use APDL-command in Workbench to do it. My question is, is it possible somehow to show the imported pressure field in Workbench so I can be able to check if everything is imported correctly? Cuz I can not be 100% sure about it by watching the results as deformation.
  
  Thanks!