We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
3D Design

3D Design

Topics related to Ansys Discovery and Ansys SpaceClaim.
  1. All Channels
  2. 3D Design
  3. cutting 3D geometry (cylinders ) on Design Modeler

cutting 3D geometry (cylinders ) on Design Modeler

    • November 15, 2017 at 5:06 pm
      bushrar
      Subscriber

      Hello,


      I was wondering if anyone knew how to make a cylinder with the entrance cut diagonally ( 2 D schematic picture enclosed) on a cone surface on Design Modeler? 


       


      Thanks!


      bushrar 

    • November 15, 2017 at 5:52 pm
      peteroznewman
      Subscriber

      You insert a Boolean Subtract operation to subtract the Cone (tool) from the Cylinder (target).

    • November 15, 2017 at 7:06 pm
      bushrar
      Subscriber

      Thanks!

Viewing 2 reply threads
  • The topic ‘cutting 3D geometry (cylinders ) on Design Modeler’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.