Learning Forum

[Lukas Hildebrand]

Dear community,

I coupled my EddyCurrent Design with Icepac and everything works except for Errors in the 3D Model which name as follows:

1) Duplicate Face ID (XXXXX) found in part XXX

1) Duplicate Edge ID (XXXXX) found in part XXX

1) Duplicate Vertex ID (XXXXX) found in part XXX

What does that mean and how can I resolve them?

Thanks,

Lukas

 

[Pdev]

Hi Lukas,

Could please share screen shots of this error? and is the simulation running? 

Best,
Pdev

[Pine Liu]

what is answer?

[Lukas Hildebrand]

Hi Pine,

the problem was that somehow the Icepac designer did not like a specific model that was duplicated around an axis and apparently gave the same id's to the duplicated one. I solved the problem by not duplicating the model around the axis, but modeling it again the same way I designed the original model.

Hope this helps.

Lukas

[Thermal Xiaomi]

Dear community,

apparently, i got the same error when I was trying to generate mesh for a MCAD model. However, the MCAD model is quite complicated and it is accomplished by another department, namely, almost impossible to fix the issue with the method metioned by Lukas to just adjust the way of modeling.

 

So, is it possible to fix this duplicate face/edge error by some operation in Spaceclaim or AEDT icepak? 

 

Best 

Xiaomi