how to set input of injection pressure in Ansys forte for closed cycle engine ?

- May 6, 2023 at 12:15 pm
  
  Anubhav .
  Subscriber
  
  How to give the input for injector's injection pressure in the diesel closed cycle sector case file?
  How to calculate the precised coefficient of discharge value in the case setup?
- May 9, 2023 at 8:27 pm
  Rahul Kumar
  Ansys Employee
  Hello,
  A suggestion would be to go over the following videos, which is a part of the diesel closed cycle simulation series:
  1. Forte for Diesel Closed-Cycle Simulation: Part 6 – Boundary and Initial Conditions – YouTube
  2. Forte for Diesel Closed-Cycle Simulation: Part 7 – Initial Conditions and Simulation Controls – YouTube
  Discharge coefficient is usually user specified and it is defined as the ratio of actual mass flow rate to the theoritical mass flow rate.