Outlet Mass Flow Rate only at one surface

- April 26, 2023 at 3:15 pm
  
  T-Ying Lin
  Subscriber
  
  Here I have attached the initial mesh with the indicators showing where I would expect the inlet and outlet flow to go, however, after completing my transient run and examining the velocity profiles I found that only one of the outlets was actually being utilized as seen here:
  I didn't think there was any issue with my setup??
- April 27, 2023 at 7:32 am
  
  Murari Iyengar
  Ansys Employee
  
  What Boundary Condition have you set for the outlets?
- April 27, 2023 at 7:37 am
  
  Murari Iyengar
  Ansys Employee
  
  If you are using Mass-flow-outlet, look at 7.4. Boundary Conditions (ansys.com) on how to define it.
- April 27, 2023 at 1:59 pm
  
  T-Ying Lin
  Subscriber
  
  Here are my initial settings