-
-
September 27, 2017 at 11:19 am
admin
Ansys EmployeeIn Adapt/Iso-Value-Adaption, you can mark cells, which have a volume fraction of one phase between 0 and 0.5. Therefore, the iso-min value should be 0 and the iso-max value should be 0.5. With this adaption register, which will be created when you have clicked on "mark", the wall-zones can be separated. Under mesh/separate/faces, the register can be selected (option: mark). For the separated (wetted) surface, the area-integral can be calculated via Report/Results Reports/Surface Integral.
-
September 27, 2017 at 11:19 am
admin
Ansys EmployeeHow can I calculate area of wetted surface for a VOF-simulation?
-
Viewing 1 reply thread
- The topic ‘Calculate area of wetted surface for a VOF-simulation’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- air flow in and out of computer case
- Varying Bond model parameters to mimic soil particle cohesion/stiction
- Eroded Mass due to Erosion of Soil Particles by Fluids
- Guidance needed for Conjugate Heat Transfer Analysis for a 3s3p Li-ion Battery
- Centrifugal Fan Analysis for Determination of Characteristic Curve
- I am doing a corona simulation. But particles are not spreading.
- Issue to compile a UDF in ANSYS Fluent
- JACOBI Convergence Issue in ANSYS AQWA
- affinity not set
- Resuming SAG Mill Simulation with New Particle Batch in Rocky
Top Contributors
-
3862
-
1414
-
1221
-
1118
-
1015
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.