We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Convergence criteria is not met while running CHT analysis in Refine mode of ANSYS Discovery 2021 R1. › Re: Convergence criteria is not met while running CHT analysis in Refine mode of ANSYS Discovery 2021 R1.

July 24, 2021 at 1:37 pm
prathap
Subscriber

Hello Subashni

I hope the problem setup was good to solve. An error free solution from your end will help to solve problems with similar setup.