Spline conversion

- February 9, 2019 at 4:02 pm
  
  Francois Fosse
  Subscriber
  
  Hi,
  Is there a way to convert lines connected together to a rounded corner to a single spline?
  Thanks,
  Francois
- February 12, 2019 at 5:41 am
  
  subashni.satish
  Forum Moderator
  
  Hello Francois Fosse
  
  1. Select the curve and the straight lines and click on 'Fit Curve' in 'Repair' tab.
  
  2. In properties uncheck all and keep only 'Spline' checked. Toggle the 'Maximum Distance' to your convenience till you get the required spline.
  - February 12, 2019 at 8:31 am
    
    Francois Fosse
    Subscriber
    
    Hello Subashni
    Thanks for your answer, I give it a try but found only the arc is moved to spline not the entire selection (line+arc+line). Do you get same behavior?
- February 12, 2019 at 8:51 am
  
  subashni.satish
  Forum Moderator
  
  Francois Fosse
  
  Try increasing the Maximum Distance and make sure you select the lines and the rounded corner
- February 12, 2019 at 10:16 am
  
  Francois Fosse
  Subscriber
  
  Yep, it works, need to split lines in small segments for better results also.
  Thanks
- March 1, 2019 at 3:26 pm
  
  Roman8
  Ansys Employee
  
  Just another note, if you use fill and click the point between the line and arc you will concatenate the curves into a single polyline.
  - March 2, 2019 at 10:58 am
    
    Francois Fosse
    Subscriber
    
    Roman Walsh
    
    Keep this one. Thanks