Learning Forum

[Roberto]

Hello

 

Sometimes there are problems in the sheet metal conversion, it does not create the spokes, can I send you a file for safe links?

I will also attach a video.
The steps are as follows
1) I try to convert it to sheet metal but I can't create the bends
2) I copy the outer surface and create a manual radius for each crease after which the convert is working
Why doesn't it work in the first steps?

 

Best Regards

[Subashni Ravichandran]

Hello Roberto

I will share with you Secure Transfer link via email. Please share the model and the video so that I can investigate this issue.

[Roberto]

Subashni Hello

were you able to see the files?

Best Regards

[Subashni Ravichandran]

Hello Roberto

I was able to create the bends by clicking on the outer side. Please check the attached geometry. 

[Roberto]

Hello Subashni

problem that as you unfolded it to you is not good because SpaceClaim does not explain it correctly

https://www.screencast.com/t/gSsfBmoBgK

If possible can you remove the file from the forum?
Thanks

 

Best Regards

[Subashni Ravichandran]

Hello Roberto

I apologise, I have removed the model. 
Unfold works based on the neighbouring faces. In the video, you have shown, I see that the selected face is unfolded in line with the neighbouring face, which is the expected behaviour

[Roberto]

Subashni Hello

The correct method of unfolding the piece must be this, completely flat

Best Regards

🛈
This post originally contained file attachments which have been removed in compliance with the updated Ansys Learning Forum Terms & Conditions

 

[Roberto]

Subashni Hello

were you able to see the video?

Best Regards

[Roberto]

Subashni Hello

no problem for the file , when I use the unfolded command the component should be completely flat , otherwise the overall dimensions would be incorrect.

 

maybe I misunderstood?

 

Best Regards

[Roberto]

Hello

 

I have not received a reply regarding the problem anymore

 

Best Regards

[Roberto]

Subashni

[Roberto]

Hello Subashni Charudatta Bandgar

I am waiting for an answer

 

Best Regards

[Subashni Ravichandran]

Hello Roberto

I will file a bug for this issue and share the bug number with you.

[Roberto]

Hello Subashni Thank you very muh

[Subashni Ravichandran]

Roberto
BUG number 390517